Event · May 2018
Demo 3 Special Workshop: Upgrading multiterminal HVDC interconnectors
A shuttle bus left the hotels of Alghero at about eight in the morning on 9 May 2018 and drove the 45 minutes inland to Codrongianos, where Terna runs the Sardinian end of SACOI, the HVDC link between Sardinia, Corsica and mainland Italy. The substation was the venue for the third BEST PATHS special workshop, and the reason was simple: SACOI was the test case for everything Demo 3 had built.
The press release issued afterwards called SACOI the first multi-terminal HVDC link in the world, and described what made it a good laboratory: three converter stations, overhead lines, land and submarine cables, sea electrodes and power flowing in every possible direction. It was also due to be fully rehabilitated after a record working life.
The programme
Antonio Iliceto of Terna, chairman of the BEST PATHS consortium, opened and closed the day, and Gianluigi Gemelli, also of Terna, shared the project overview. The technical talks followed the Demo 3 work plan:
- Massimo Marzinotto (Terna): an introduction to Demo 3, and later the insulation of HVDC overhead lines
- Giovanni Garzi and Renata Bachega (Toshiba): an innovative HVDC converter
- Diego Cirio (RSE): advanced HVDC control functions and a techno-economic analysis
- Roberto Gaspari (Nexans): submarine and land cables with XLPE insulation for DC
- Davide Peroni and Giacomo Sarti (De Angeli Prodotti): high temperature low sag conductors for DC lines
In the afternoon, Antonio Battaglia led a visit to the SACOI converter, followed by the synchronous condenser plant and the Storage Lab with its large electrochemical batteries.
Iliceto’s claim for the work was a wide one: “The full range of innovations for High Voltage Direct Current components developed in Best Paths can be applied in rehabilitating other existing interconnections as much as in newly built ones.” The HTLS conductors, made in Kevlar and in carbon fibre versions, stood out; at the project’s final conference four months later they were described as first-of-a-kind HVDC conductors for overhead lines.
SACOI itself is still running, at 300 MW and 200 kV over 385 km, 121 km of it under the sea, and its replacement, SACOI 3, is under construction as a 400 MW, ±200 kV bipole with operation forecast for 2029; the full record is on the SACOI page, and the components behind the workshop on the Demo 3 page.